[. . . ] The equipment shall go on-hook for period of not less than 30 seconds between the end of one attempt and the beginning of the next attempt 2. Where automatic calls are made to different numbers, the equipment shall go on-hook for a period of not less than 5 seconds between the end of one attempt and the beginning of the next attempt 3. The equipment shall be set to ensure that calls are answered between 3 and 30 seconds of receipt of ringing © Copyright SONY Corporation 2000 1 Warning notices to New Zealand users of the built-in modem a. [. . . ] The equipment shall be set to ensure that calls are answered between 3 and 30 seconds of receipt of ringing © Copyright SONY Corporation 2000 1 Warning notices to New Zealand users of the built-in modem a. A person calling your modem will hear a short burst of ringing before the modem answers. This confirms that the call has been successfully switched through the network. Caller identification information (which occurs between the first and second ring cadences) is not destroyed. The pulse dialling option is not compatible with the Telecom Network and must not be used. This equipment shall not be used in any circumstances which may constitute a nuisance to other Telecom Customers. The following setup AT commands should be used for correct operation: AT19 = North America AT% T19, 0, 19(North America) AT%T21, B, 2 AT%T21, B, 6 NOTE THAT FAULT CALLOUTS CAUSED BY FAILURE TO ADHERE TO THE ABOVE NOTES MAY INCUR A CHARGE FROM TELECOM. Notice for SONY 10/100 Ethernet Mini PCI Adapter with 56K Modem (by 3COM) users For the modem with approval number PTC 211/99/255: Not all phones connected to the phone port will respond to incoming ringing. Do not report this as a fault unless the same phone will not respond to ringing when connected to a standard phone socket. This confirms that the call has been successfully switched through the network. 2) Caller identification information (which occurs between the first and second ring cadence) is not destroyed. Performance limitations may occur when used in conjunction with some parts of the network. Telecom will accept no responsibility should difficulties arise in such circumstances. The code for Call Waiting disable is *52 on the Telecom New Zealand telephone network Notice for Built-in Modem Users 3 Notice for SONY 10/100 Ethernet Mini PCI Adapter with 56K Modem (by 3COM) users Notice for SONY 10/100 EtherJet Mini PCI Adapter with 56K Modem users For the modem with approval number PTC 211/99/172: New Zealand Telepermit Compliance Notes General The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product is compatible with all of Telecom's network services. Important Notice Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the equipment (PC) associated with this device. [. . . ] Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product is compatible with all of Telecom's network services. Important Notice Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the equipment (PC) associated with this device. The associated equipment shall be set to operate within the following limits for compliance with Telecom's Specification: 1. [. . . ]